At a glance
Dexora combines a 36-DoF dual-arm, dual-hand platform, matched simulation/real demonstrations and a discriminator that weights diffusion-policy training. Its main results are 89.6% mean basic-task success and 66.7% dexterous-task success, compared with the strongest listed baseline’s 82.1% and 51.7%. These are results on small, specified test suites; robot transfers require task demonstrations, and cap twisting remains difficult.
I Introduction
The work targets coordinated arm motion and fine finger control in one policy. Two 6-DoF arms and two 12-DoF hands support handovers, constrained retrieval and torsional tasks that simpler tested configurations handle poorly. An exoskeleton captures arm motion, Vision Pro tracks fingers, and the same interface controls a physical robot and a MuJoCo twin.
The central recipe is simulation pretraining followed by real-data specialization with quality weighting. The claim of a universal high-to-low-dimensional controller is a hypothesis motivated by adapted examples, not a theorem about arbitrary robot kinematics. This edition follows all eight pages of the 18 May 2026 v1, retaining all eleven figures, three tables, eight numbered equations and 44 references. Original resources are linked at the project site.

II Related Work
II-A Teleoperation System
Teleoperation can use leader–follower rigs, headsets, vision retargeting, exoskeletons or handheld controls. The hybrid setup combines joint-space arm capture, as in AirExo, with glove-free finger tracking related to Bunny-VisionPro. Matching the interface across physical and simulated embodiments makes collected commands consistent; the paper does not isolate interface latency or operator fatigue in a quantitative comparison.
II-B Dexterous Manipulation
Prior work separates grasp synthesis from policy learning. Diffusion, flows, latent generative models and optimization produce grasps; reinforcement and imitation learning turn them into control. DexMimicGen scales demonstrations through retargeting, while EgoVLA uses human video. Dexora’s emphasis is language-conditioned coordination of both arms and high-dimensional hands, rather than grasp generation alone.
II-C Vision-Language-Action (VLA) Model
RT-2, OpenVLA and GraspVLA motivate generalist robot policies; π₀, RDT and GR00T N1 extend the architectural and embodiment range. The source’s coverage diagram is a selected comparison, not an exhaustive proof of priority. Dexora learns synchronized arm–hand action chunks, then fine-tunes for simpler robots.

III Dexora
The system links four components: a shared hardware/simulation interface, task-diverse demonstrations, a conditional diffusion policy and an offline quality scorer. The scorer influences training weights and is removed at deployment.
III-A Dual-Arm Dual-hand System
Each AIRBOT arm has six joints and each XHAND twelve independently actuated joints; thumb/index lateral motion supports reorientation and twisting. The backpack maps measured arm angles directly into robot joint commands. Vision Pro finger skeletons are calibrated and retargeted with joint limits. Four RGB views and all 36 joint states are synchronized at 20 Hz.
The MuJoCo twin shares kinematics, controllers and teleoperation drivers with the physical system. This reduces an interface mismatch but does not establish equality of contact physics or sim-to-real performance. The authors attribute smoother arm commands to avoiding vision-only inverse-kinematics jitter; that attribution is not separately benchmarked.
III-B Dataset Construction
Simulation. Qwen2.5-VL selects manipulable Objaverse objects and proposes physical parameters, layouts and success criteria. For each of 200 tasks, three to five demonstrations seed DexMimicGen-style retargeting to randomized scenes, producing 500 trajectories per task: 100,000 total, with 6.5 million reported frames. Figure 4 shows 297 simulation objects in 30 categories.
Real data. Two hundred tasks with fifty demonstrations each yield 10,000 episodes, including tool use and a 20% dexterous-task share. Figure 4 lists 347 objects in seventeen categories. Data are converted to the stated LIBERO-2.1 format. The methods report 40.5 hours and 2.92 million real frames; the introduction instead says 177.5 hours and 3.2 million. The simulation’s 361 video-hours also has an unclear per-view counting convention at the stated 20 Hz. These totals should not be treated as a single reconciled duration account.

III-C Framework
Quality labels. Joint states are min–max normalized, then centered finite differences produce velocity, acceleration and jerk. Equations 2–3 aggregate acceleration and jerk over time and dimensions. The intersection of the lowest 20% by each metric retains about 18% of episodes; replayed task success without collisions reduces this to about 15% positives. A movement-coverage guard is mentioned to reject uninformative stationary behavior, but its threshold is not specified.
Discriminator. Uniformly sampled subclips contain state, action chunks and a frozen-policy compatibility score, conditioned on language and images. Equations 4–5 use standardized negative denoising residual energy. This is a relative compatibility proxy, not an evaluated action log-likelihood. The printed formula omits explicit diffusion-step/noisy-action notation, and the number of sampled clips/steps and clip-to-episode aggregation are unspecified. Transformer features are pooled and passed through an MLP/sigmoid quality head.
Policy. A decoder-only diffusion Transformer combines state, noisy action and timestep tokens with alternating T5 language and SigLIP image conditioning. It predicts action noise, using DDPM training and DPM-Solver++ inference. The policy emits synchronized joint-command chunks; the discriminator is unnecessary during execution.
Equations 1–5
| (1) |
| (2) | ||||
| (3) |
| (4) |
| (5) |

Equation 6
| (6) |
III-D Data-quality-aware Training Recipe
First pretrain the policy on simulation; then freeze it to compute compatibility features and train the discriminator; finally post-train the policy on all real demonstrations using precomputed weights. Equation 7 assigns replay-validated positives a weighted binary-cross-entropy target of one and treats the remaining, unlabelled pool as negative, with η=0.5.
Although called positive–unlabelled learning, the displayed objective has no correction for genuine high-quality examples remaining in that negative pool. Scores are clipped to [0.1, 0.9], then mapped to weights following discriminator-weighted behavior cloning. The mapping, claimed calibration procedure and warm-up duration are not reproduced. Equation 8 preserves the weighted denoising loss; the scores should be read as practical reweighting signals rather than certified quality probabilities.
Equations 7–8
| (7) |
| (8) |
IV EXPERIMENT
Experiments cover native-platform basic and dexterous skills, six visual/environmental shifts of one task, adapted embodiments, and separate data-composition/discriminator ablations. Each reported task evaluation uses twenty rollouts, so individual-task outcomes change in five-percentage-point steps. Training-seed uncertainty and confidence intervals are not reported.
IV-A Experimental Setup and Baselines
The policy has 28 layers, width 1024 and sixteen attention heads. The 30-million-parameter discriminator has twelve layers, width 512 and eight heads. Policy pretraining runs 100,000 steps and discriminator training 10,000, using AdamW, eight A100 GPUs and total batch size 64.
Diffusion Policy directly predicts the 36-dimensional action. π₀ uses a two-layer projector factored into left/right arm/hand groups to expand its native outputs; GR00T N1 is the strongest baseline. Chunk length is 32, with matched cameras, views and control frequency. Baselines receive 100 demonstrations per task and 50,000 fine-tuning steps; the protocol uses LoRA on four L20 GPUs and RTX 4090 inference. Basic Dexora results are described as zero-shot, whereas dexterous and cross-robot experiments explicitly fine-tune with demonstrations. Different prior training and hand capacities remain comparison factors.
IV-B Evaluation Results in Real World
Basic tasks. Table I contains five pick/place, five assembly/disassembly and two articulated-object tasks. Dexora’s mean is 89.6%, versus GR00T 82.1%, π₀ 50.4% and DP 34.2%; seven of twelve tasks reach at least 90%. It leads the shaded bimanual tasks, but GR00T is better on ring stacking (90 versus 85) and ties bowl placement and square-block retrieval. Thus the abstract’s 90% is a rounded aggregate, not a universal task success rate. The basic evaluation is called zero-shot after corpus training; the paper does not detail overlap between test tasks and the 200-task training corpus.
Dexterity. With 100 task demonstrations, the six-task average is 66.7%, versus GR00T 51.7%, π₀ 26.7% and DP 6.7%. Dexora improves five tasks over GR00T, but cuts leek at 80 versus 85. Cap twisting is only 25%, though all baselines score zero. The authors identify absent tactile feedback and low-friction rigid fingertips as causes of slipping. Their 12-DoF versus baseline 6-DoF hand comparison couples model/data changes with physical dexterity, so it does not isolate the learning algorithm’s contribution.
Original selectable table
| Method | Pick and Place | Assemble / Disassemble | Articulated Object | Avg. | |||||||||
| Apple plate | Bowl bowl | Two eggs box | Lift basket | Left block right plate | Stack ring blocks | Grab square blocks | Place kettle on base | Remove pen cap | Separate nested bowls | Open cabinet door | Open laptop | ||
| DP | 60 | 65 | 30 | 10 | 25 | 35 | 15 | 45 | 30 | 10 | 65 | 20 | 34.2 |
| 75 | 70 | 45 | 30 | 30 | 60 | 60 | 65 | 55 | 20 | 60 | 35 | 50.4 | |
| GR00T N1 | 95 | 100 | 75 | 60 | 80 | 90 | 80 | 90 | 80 | 60 | 95 | 80 | 82.1 |
| Dexora | 100 | 100 | 85 | 80 | 90 | 85 | 80 | 95 | 90 | 80 | 100 | 90 | 89.6 |
Original selectable table
| Method | Use pen | Fetch book | Cut leek | Place plates | Rough dough | Twist cap |
| DP | 5 | 10 | 10 | 0 | 15 | 0 |
| 20 | 45 | 60 | 20 | 15 | 0 | |
| GR00T N1 | 45 | 60 | 85 | 60 | 60 | 0 |
| Dexora | 65 | 80 | 80 | 70 | 80 | 25 |

IV-C Generalization
Environmental shifts. For apple-to-plate, Figure 8 reports 100% in the base setting and unseen background, 95% under new lighting, object or height, and 90% under occlusion or clutter. Each uses twenty rollouts. This is a one-task robustness test, not evidence for all dexterous tasks or arbitrary combinations of shifts.
Other robots. Examples cover a single-arm Panda/gripper, dual-arm Cobot Magic ALOHA grippers, and a Unitree G1 arm with Inspire Hand. Unused action dimensions are padded and absent cameras masked; every transferred task receives 100 fine-tuning demonstrations. Figure 9 shows stacking, placing, pouring and a pepper handover, but no quantitative per-embodiment success table is supplied. Dimensional reduction alone does not establish a correct mapping between distinct kinematics, and these adapted examples do not demonstrate zero-shot universal control.


IV-D Ablation Study
Data composition. Figure 10 compares simulation only, simulation plus half the real tasks, and simulation plus all real tasks. Apple-to-plate rises 75→90→100%; ring stacking 65→80→85%; pen use 0→35→65%; leek cutting 10→60→80%. The prose instead gives the last value as 85%, while the plotted label and main table say 80%. Adding real data also expands task coverage, including dexterity absent from the synthetic task set, so the experiment does not isolate realism from diversity.
Quality weighting. Table III raises corn-to-plate success from 85 to 95% and basket lifting from 55 to 80%. Normalized acceleration falls 0.034→0.020 and 0.041→0.023; jerk falls 0.043→0.032 and 0.052→0.036. Figure 11 shows selected joint traces and failures. This supports the complete weighting recipe on two tasks, without separating smoothness filtering, replay validation, compatibility features and learned scoring, or establishing reliability across seeds.
V CONCLUSION
The contribution is an integrated high-dimensional demonstration and learning system: embodiment-matched simulation provides scale, real demonstrations supply contact-rich skills, and offline scoring helps prioritize useful behavior. The observed gains come with restricted evaluation coverage, incomplete training-detail specification and important tactile-control failures. Proposed future work adds tactile feedback and longer-horizon memory, subgoals and planning; those capabilities are not demonstrated here.